ADVERTISEMENT

Mactac Unveils New Cryogenic Labels

Mactac, a North American adhesives, label and packaging company, has launched new cryogenic labelstocks for temperatures as low as -320º F. Mactac’s cryogenic labelstocks are intended for harsh environment applications where labels must withstand exposure to liquid nitrogen or ultralow temperature freezers, thaw cycles, chemicals and solvents.

Coregas Supporting Coal-to-Hydrogen Project in Australia

A world-first project in Victoria, Australia, that will convert brown coal to hydrogen for export to Japan is being supported by the only Australian-owned industrial gas company, Coregas. The Hydrogen Energy Supply Chain (HESC) project will see liquefied hydrogen produced from Latrobe Valley brown coal transported to Japan for use...

They Are There and They Are Gone: ICARUS Chases a Fourth Neutrino

On February 21, scientists at Fermi National Accelerator Laboratory (Fermilab) (CSA CSM) began cooling down ICARUS—the largest particle detector in the lab’s Short-Baseline Neutrino Program—and filling it with 760 tons of liquid argon. This moves ICARUS closer to operation and the search for a fourth type of neutrino. “The Short-Baseline...

ADVERTISEMENT

Cold Compressors

A common way to provide cooling below the normal boiling point of helium (4.2K) is to reduce the pressure above the bath of liquid helium, thus also reducing the bath’s equilibrium saturation temperature. For example, to produce a 1.8K bath of liquid helium, the saturation pressure has to be reduced...

Kapitza Conductance

Kapitza conductance refers to the heat transfer between a solid surface and a fluid that covers that surface. Fundamentally, it describes the inherent difficulty in transferring energy from a solid to the fluid covering the solid surface. This phenomenon was first observed by P. L. Kapitza in 1941 while studying...

Thermosyphons

A thermosyphon (or thermosiphon) is a device that transfers heat via natural convection in a fluid. The natural convection is driven by gravity with the colder, denser fluid flowing downhill and the warmer, less dense fluid flowing back up. Thus, thermosyphons connect an object to be cooled with a reservoir...

Air Separation and Liquefaction

by Nils Tellier, PE, President, EPSIM Corporation (CSA CSM) nils@epsim.us All illustrations courtesy EPSIM Corporation Background History of Air Separation and Liquefaction This section builds on a rich history of methods to develop deep refrigeration and cryogenic liquefaction during the 19th Century. You are encouraged to read Cryo Central’s History...

Bose-Einstein Condensate

A Bose-Einstein condensate, first proposed in 1925 by Albert Einstein based on work done by Satyendra Nath Bose (the same Bose from whom the term boson is derived), is a super-cold state of matter in which almost all of the individual atoms have “condensed” down to the lowest possible quantum...

Cold Technology for Pest Control

While it does not reach temperatures cold enough to be called cryogenic, carbon dioxide snow is at the heart of a new way of dealing with unwanted pests. It utilizes a quick freezing process that takes advantage of the properties of carbon dioxide snow and has a number of benefits...

Cryogenic Finishing

The following 3 articles discuss the uses and procedures of various type of cryogenic finishing. 1) By Robin A. Rhodes, Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Cryogenic Deflashing is employed to remove undesired residual mold flash that remains on molded parts after they are removed or ejected from the...

Seeking recommendations for commercial sensors

I would like to measure vibrations in small LHe cryostats. Could anybody recommend commercial sensors which would be suitable for the purpose? I am interested in the frequency range between 1Hz and a couple of KHz, with particular attention to the low frequency side.

Estimating cost of carbon steel, pure helium storage tanks

In order to perform an indicative cost assessment of our helium cryogenic plant (still in the design phase), I need an estimation of the cost of carbon steel room temperature pure helium storage tanks. The storage pressure is 20 bar. Can anyone give me suggestions about how to estimate the...

Supplier of pressure sensor that works down to 4.2 K

In an actual experiment we would like to measure the static pressure in a cryostat in the range between one and four bar. Therefore we are looking for some (more or less) cheap pressure sensors that work in liquid helium in the pressure range up to five bar. Unfortunately all...

Looking for reference/textbook suggestions

Can you suggest some reference textbooks for practical thermodynamics applications in cryogenic fields? I need textbooks with cryogenics calculations and examples, dimensioning procedures, second principle applications in cryogenics, heat load calculations, cryogenic pump application, etc. Do such books exist? Does any similar source of information exist?