ADVERTISEMENT

New Payload Fairing from RUAG Space Enables Quieter Journey to Space

RUAG Space (CSA CSM) has successfully developed and tested a new, low shock jettison system funded by the Future Launchers Preparatory Program (FLPP) of the European Space Agency (ESA). The program develops technologies for future European launch vehicles and upgrades of existing launch vehicles. This system enables a quieter and...

LN2 Freezing of Live Bacteria in Dairy Products Boosts Productivity, Lowers Costs

GEA, an Australian electrical component company, has now launched a nitrogen freezing pilot plant for bacteria which takes a novel approach: freezing the bacteria in droplets using a liquid nitrogen bath outside the freeze dryer, then drying the pellets via the normal procedure. By freezing bacteria into pellets before drying,...

Thales Cryogenics, Eindhoven Receives NASA Awards

NASA has awarded the cryogenics department at Thales, Eindhoven two recognitions at its 2019 Honors ceremony held at the Jet Propulsion Laboratory in Pasadena the week of November 11. Both were awarded for Thales’ contribution to the success of the ongoing ECOSTRESS mission. The group received the NASA Group Achievement...

Hahn Shot First

After 32 years as Fermilab’s staff photographer, Reidar Hahn is retiring – and saying farewell with a final collection of photos in Fermilab’s art gallery. Hahn has graciously allowed CSA to display some of his best work in future issues of Cold Facts and a CSA online photo gallery.

ADVERTISEMENT

Helium II

Helium II (He II) refers to the second liquid phase of the most abundant helium isotope (4He). Helium II is also referred to as superfluid helium. Helium II occurs once the temperature of the liquid helium drops below 2.17K. The phase transition between the first liquid phase of Helium (referred...

Primary Standards

Elie K. Track Hypres, Inc. elie@hypres.com http://www.hypres.com/ Primary standards involve the exact definition and realization of units of measurement for various quantities, time, length, mass, voltage, resistance, current, etc. International agreements based on the latest scientific knowledge define those units, and their realizations vary depending on the unit itself. For...

Shrink Fitting

Robin A. Rhodes Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Shrink fitting, (or “compression fitting” as it is sometimes called), is a method used to insert a pin or bushing into a housing or other assembly requiring an extremely tight tolerance fit. It can be used as an alternative to...

Telecommunications

From the Winter 2004 issue of Cold Facts magazine The recent M-Calc IV — 4th Industry Assessment workshop discussing military and commercial applications for low-cost cryocoolers, held in November in San Diego, highlighted progress being made in cryogenics as applied in telecommunications. The reliability and long lifetime of projects now...

Wind Tunnels

Dr. Robert Kilgore The development of the cryogenic wind tunnel is one of many significant breakthroughs in both cryogenics and wind-tunnel technology made during the past millennium. Interest in the development of high-speed commercial and military aircraft resulted in a review of problems of flow simulation in transonic wind tunnels...

An Issue of Pressure and Flow Rate in a Supply Tank

Please help solve this problem: A supply tank requires a vaporizer to generate sufficient pressure to pump stored fluid up into a vehicle or tank. The available head is limited as the tank level falls and it is important to minimize the system pressure drop to maintain the desired flow...

Using MLI on VJ Line Joints or Cryo Storage Tanks

When installing Multi Layer Insulation (MLI) blankets on VJ line joints or cryo storage tanks should they be wrapped and tied down tight or loose? These are usually pre-cut to size. Also should they have an access hole at the point of where the molecular sieve is installed to help...