ADVERTISEMENT

Whole Body Cryotherapy

Interest in low temperature treatment is increasing and whole body cryotherapy (WBC) devices are becoming available not only in medical centers but also in local gyms and spa centers. Many governments and medical professionals have thus turned attention to WBC, evaluating the treatment for its effectiveness and safety. The US...

Cryocoolers 19 Proceedings Available Now

"Cryocoolers 19," a 654-page compilation of the proceedings of the 19th International Cryocooler Conference held in San Diego, California, June 20-23, 2016, is now available and has been mailed to registered participants. Published by ICC Press, Boulder, Colorado, and edited by S.D. Miller and R.G. Ross, Jr., the volume features...

CERN Ramps Up Neutrino Program

In the midst of the verdant French countryside looms a workshop the size of an aircraft hangar. Inside, CERN technicians are busy constructing two 8-meter tall cubes to test prototype detectors for the Deep Underground Neutrino Experiment (DUNE). Each will in time contain 770 metric tons of liquid argon permeated...

NIST Physicists Squeeze Light, Cool Microscopic Drum below Quantum Limit

Physicists at the National Institute of Standards and Technology (NIST) have cooled a microscopic mechanical drum to less than one-fifth of a single quantum, or packet of energy. The result, according to the research team, is lower than ordinarily predicted by quantum physics and the technique used could theoretically cool...

Ultracold Liquid Hydrogen May Be Fuel of the Future

NASA has wrapped up testing on a new cooling system that supercools hydrogen to -423°F. It's housed in a shuttle-era storage facility engineers saved from demolition five years ago at the agency’s Kennedy Space Center in Florida and thereafter transformed into a test site for new ground operations demo units.

ADVERTISEMENT

Two-Phase Flows

Two-phase flows are those flows in which there is a mixture of two physical states (solid, liquid or vapor). In cryogenic applications, such flows are almost always a mixture of a cryogenic liquid along with its corresponding vapor. A mixture of liquid helium and helium vapor would be a typical...

Supercritical Fluids

A supercritical fluid is defined as a substance whose temperature and pressure exceed those of its critical point. Every pure substance has a critical point that is defined in thermodynamic space by a critical temperature and a corresponding critical pressure. For example, the critical point for helium has a critical...

Brayton Cycle

The Brayton cycle is one of the many thermodynamic cycles used to generate cooling at cryogenic temperatures. Strictly speaking, when referring to cooling we should call this the reverse Brayton cycle as the original Brayton cycle describes the process of power generation or propulsion via a gas turbine. In many...

Air Separation and Liquefaction

by Nils Tellier, PE, President, EPSIM Corporation (CSA CSM) nils@epsim.us All illustrations courtesy EPSIM Corporation Background History of Air Separation and Liquefaction This section builds on a rich history of methods to develop deep refrigeration and cryogenic liquefaction during the 19th Century. You are encouraged to read Cryo Central’s History...

Bose-Einstein Condensate

A Bose-Einstein condensate, first proposed in 1925 by Albert Einstein based on work done by Satyendra Nath Bose (the same Bose from whom the term boson is derived), is a super-cold state of matter in which almost all of the individual atoms have “condensed” down to the lowest possible quantum...

Cold Technology for Pest Control

While it does not reach temperatures cold enough to be called cryogenic, carbon dioxide snow is at the heart of a new way of dealing with unwanted pests. It utilizes a quick freezing process that takes advantage of the properties of carbon dioxide snow and has a number of benefits...

Cryogenic Finishing

The following 3 articles discuss the uses and procedures of various type of cryogenic finishing. 1) By Robin A. Rhodes, Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Cryogenic Deflashing is employed to remove undesired residual mold flash that remains on molded parts after they are removed or ejected from the...

Getter materials to absorb out gassed materials?

Here’s one for the scientists: We would like to sell vacuum insulated pipe for high temperature fluid applications. Are there any good getter materials that we can place in the vacuum space of our VJP to absorb outgassed materials at elevated temperatures?