ADVERTISEMENT

Heavy fermions get nuclear boost on way to superconductivity

Physicists from the United States, Germany and China have discovered nuclear effects that help bring about superconductivity in ytterbium dirhodium disilicide (YRS), one of the most-studied materials in a class of quantum critical compounds known as "heavy fermions." The discovery marks the first time that superconductivity has been observed in...

Metamaterials Boost Sensitivity of MRI Machines

A group of researchers from Russia, Australia and the Netherlands have developed a technology that can reduce Magnetic Resonance Imaging (MRI) scanning times by more than 50 percent, allowing hospitals to drastically increase the number of scans without changing equipment. Scientists achieved this leap in efficiency by placing a layer...

Scientists push boundaries of antimatter research in quest for answers

Scientists of the international ALPHA Collaboration have pushed the boundaries of antimatter research with a breakthrough studying the properties of antihydrogen. Published in the journal Nature, the collaboration's result improved the measurement of the charge of antihydrogen, essentially zero, by a factor of 20. The work is the latest contribution...

New Dream Team Leading CERN

Fabiola Gianotti officially began her term as CERN's new—and first female—Director General on January 1, bringing with her a group CERN describes as a "new dream team." Gianotti earned her PhD in experimental particle physics from the University of Milan in 1989 and joined CERN as a researcher in 1994....

Generations of Tesla experts celebrate family reunion at TCC

Experts on superconducting radio frequency technologies (SRF) from all over the world came to the SLAC National Accelerator Laboratory in December for the Tesla Technology Collaboration (TTC) meeting. Akira Yamamoto, Asian director of International Linear Collider (ILC), said the TCC reminded him of a family reunion where everything from technical...

ADVERTISEMENT

Helium-3

Helium-3 (3He) is one of the two stable isotopes of helium. The other is the much more common Helium-4 (4He). Neither of these isotopes should be confused with He II, which is the second liquid phase of 4He. He II was discussed in this column in the Spring 2010 edition...

Cryopumping

Cryopumping refers to the use of cryogenic temperatures to produce vacuum in enclosed spaces. More broadly, it can also refer to the removal of gases via cryogenic temperatures from a flow stream or enclosure without necessarily resulting in vacuum pressures. This is an important application of cryogenics and is used...

Thermal Acoustic Oscillations

Thermal Acoustic Oscillations (TAO) are a common event in cryogenic systems that can have significant adverse effects on the performance of the system. TAOs are sustained pressure oscillations that can occur in tubes containing gas, closed at one end (the warm end) that have a very large temperature gradient along...

Air Separation and Liquefaction

by Nils Tellier, PE, President, EPSIM Corporation (CSA CSM) nils@epsim.us All illustrations courtesy EPSIM Corporation Background History of Air Separation and Liquefaction This section builds on a rich history of methods to develop deep refrigeration and cryogenic liquefaction during the 19th Century. You are encouraged to read Cryo Central’s History...

Bose-Einstein Condensate

A Bose-Einstein condensate, first proposed in 1925 by Albert Einstein based on work done by Satyendra Nath Bose (the same Bose from whom the term boson is derived), is a super-cold state of matter in which almost all of the individual atoms have “condensed” down to the lowest possible quantum...

Cold Technology for Pest Control

While it does not reach temperatures cold enough to be called cryogenic, carbon dioxide snow is at the heart of a new way of dealing with unwanted pests. It utilizes a quick freezing process that takes advantage of the properties of carbon dioxide snow and has a number of benefits...

Cryogenic Finishing

The following 3 articles discuss the uses and procedures of various type of cryogenic finishing. 1) By Robin A. Rhodes, Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Cryogenic Deflashing is employed to remove undesired residual mold flash that remains on molded parts after they are removed or ejected from the...

Power usage: cryogenic systems vs. regular refrigerators

A recent project highlighted to me that closed cycle cryogenic cooling systems use far more electrical power to reduce temperatures by a few watts than regular refrigerators. I am sure it must be something to do with the extra difficulty of removing the heat from the liquid nitrogen or similar...

Redundancy strategies for mechanical -80C freezers

I was wondering what kind of redundancy strategies are people using for their mechanical -80C freezers? I am aware of the following. Please add if you are doing something different. 1) 1 Backup freezer for every 10 freezers – Empty and maintained at -80C at all times 2) Backup C02...

Method to move components in a cryogenic environment

Does anyone know of a method with which to reliably move components in a cryogenic environment? We are interested in moving detectors in a cryogenically cooled (2K) vacuum chamber, which is contained within a larger cryostat/isolation vacuum with thermal shields. As the desired horizontal or vertical displacement is between 10...