ADVERTISEMENT

Georgia Tech researchers use ultra cold chemistry to study atoms

Researchers at the Georgia Institute of Technology have received a $900,000 grant from the US Air Force Office of Scientific Research to study the unusual chemical and physical properties of atoms and molecules at micro-kelvin or nano-kelvin temperature ranges approaching absolute zero, the temperature at which all thermal activity stops....

Cosmological simulation models birth of universe

Researchers led by scientists at the US Department of Energy's (DOE's) Argonne National Laboratory have performed one of the largest cosmological simulations ever. Run on the Titan supercomputer at DOE's Oak Ridge National Laboratory, the simulation modeled the evolution of the universe from just 50 million years after the Big...

Fermilab attains unprecedented quality factor for superconducting cavity

Fermilab announced November 6 that researchers had recorded a record-high quality factor while performing integrated tests on a new superconducting radio frequency cavity for the SLAC-headed Linac Coherent Light Source II project. Quality factor (Q) is a measure of a particle acceleration cavity's efficiency. A higher Q means a cavity...

MicroBooNE detects accelerator-born neutrinos

The MicroBooNE collaboration announced on November 2 that its researchers had recorded neutrinos for the first time. The sighting marks the beginning of detailed studies of these fundamental particles whose properties could be linked to dark matter, matter’s dominance over antimatter in the universe and the evolution of the entire...

Layered Thermal Insulation Systems for Below-Ambient Temperature Applications

With increasing system control and reliability requirements as well as demands for higher energy efficiencies, thermal insulation in extreme environments is a growing challenge prompting the publication of new technical consensus standards for cryogenic insulation testing and multilayer insulation (MLI) systems. Different layered thermal insulation systems such as MLI and...

ADVERTISEMENT

Joule-Thomson Effect

The Joule-Thomson (JT) effect is a thermodynamic process that occurs when a fluid expands from high pressure to low pressure at constant enthalpy (an isenthalpic process). Such a process can be approximated in the real world by expanding a fluid from high pressure to low pressure across a valve. Under...

Current Leads

One of the challenges of using superconducting magnets is the connection of the magnet to a room temperature power supply. This is accomplished via current leads. The trick is that current leads should ideally have a low heat leak, since they connect room temperature to cryogenic temperature, while at the...

Multilayer Insulation

Multilayer insulation (also referred to as superinsulation) is a key component in the reduction of heat leak to cryogenic systems due to thermal radiation. MLI consists of a series of uncooled reflective surfaces placed in the vacuum space between two surfaces, one warmer than the other. Generally speaking, for ideal...

Air Separation and Liquefaction

by Nils Tellier, PE, President, EPSIM Corporation (CSA CSM) nils@epsim.us All illustrations courtesy EPSIM Corporation Background History of Air Separation and Liquefaction This section builds on a rich history of methods to develop deep refrigeration and cryogenic liquefaction during the 19th Century. You are encouraged to read Cryo Central’s History...

Bose-Einstein Condensate

A Bose-Einstein condensate, first proposed in 1925 by Albert Einstein based on work done by Satyendra Nath Bose (the same Bose from whom the term boson is derived), is a super-cold state of matter in which almost all of the individual atoms have “condensed” down to the lowest possible quantum...

Cold Technology for Pest Control

While it does not reach temperatures cold enough to be called cryogenic, carbon dioxide snow is at the heart of a new way of dealing with unwanted pests. It utilizes a quick freezing process that takes advantage of the properties of carbon dioxide snow and has a number of benefits...

Cryogenic Finishing

The following 3 articles discuss the uses and procedures of various type of cryogenic finishing. 1) By Robin A. Rhodes, Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Cryogenic Deflashing is employed to remove undesired residual mold flash that remains on molded parts after they are removed or ejected from the...

Getter materials to absorb out gassed materials?

Here’s one for the scientists: We would like to sell vacuum insulated pipe for high temperature fluid applications. Are there any good getter materials that we can place in the vacuum space of our VJP to absorb outgassed materials at elevated temperatures?