ADVERTISEMENT

Brookhaven dedicates “brightest beacon at the frontiers of discovery”

The National Synchrotron Light Source II (NSLS-II) at Brookhaven Laboratory was dedicated February 6. NSLS-II, which produces extremely bright beams of X-ray, ultraviolet and infrared light, will examine a wide range of materials, including superconductors and catalysts, geological samples, and biological proteins, to accelerate advances in energy, environmental science and...

First prototypes of high-voltage feedthrough

With the delivery of two feedthrough samples for the 6 pin 30 KV rating, identified as a type D variant, Ceramtec North America Corporation (US) has begun to solve one of the big challenges at ITER.

What’s new for LHC Run II

Since shutting down in early 2013, the LHC and its detectors have undergone a multitude of upgrades and repairs. When the particle accelerator restarts, it will collide protons at an unprecedented energy: 13 trillion electron volts. The upgraded capabilities of the ATLAS, CMS, ALICE and LHCb detectors—plus the LHC’s extra...

Potential of molybdenum disulfide for extreme-temperature electronics

Many industries are calling for electronics that can operate reliably in a harsh environment, including extreme temperatures above 200°C. A team of researchers from the University of California, Riverside and Rensselaer Polytechnic Institute discovered that molybdenum disulfide, a semiconductor material, may be a promising candidate to make thin-film transistors for...

ADVERTISEMENT

Helium II

Helium II (He II) refers to the second liquid phase of the most abundant helium isotope (4He). Helium II is also referred to as superfluid helium. Helium II occurs once the temperature of the liquid helium drops below 2.17K. The phase transition between the first liquid phase of Helium (referred...

Air Separation and Liquefaction

by Nils Tellier, PE, President, EPSIM Corporation (CSA CSM) nils@epsim.us All illustrations courtesy EPSIM Corporation Background History of Air Separation and Liquefaction This section builds on a rich history of methods to develop deep refrigeration and cryogenic liquefaction during the 19th Century. You are encouraged to read Cryo Central’s History...

Bose-Einstein Condensate

A Bose-Einstein condensate, first proposed in 1925 by Albert Einstein based on work done by Satyendra Nath Bose (the same Bose from whom the term boson is derived), is a super-cold state of matter in which almost all of the individual atoms have “condensed” down to the lowest possible quantum...

Cold Technology for Pest Control

While it does not reach temperatures cold enough to be called cryogenic, carbon dioxide snow is at the heart of a new way of dealing with unwanted pests. It utilizes a quick freezing process that takes advantage of the properties of carbon dioxide snow and has a number of benefits...

Cryogenic Finishing

The following 3 articles discuss the uses and procedures of various type of cryogenic finishing. 1) By Robin A. Rhodes, Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Cryogenic Deflashing is employed to remove undesired residual mold flash that remains on molded parts after they are removed or ejected from the...

An Issue of Pressure and Flow Rate in a Supply Tank

Please help solve this problem: A supply tank requires a vaporizer to generate sufficient pressure to pump stored fluid up into a vehicle or tank. The available head is limited as the tank level falls and it is important to minimize the system pressure drop to maintain the desired flow...

Using MLI on VJ Line Joints or Cryo Storage Tanks

When installing Multi Layer Insulation (MLI) blankets on VJ line joints or cryo storage tanks should they be wrapped and tied down tight or loose? These are usually pre-cut to size. Also should they have an access hole at the point of where the molecular sieve is installed to help...