ADVERTISEMENT

Brookhaven dedicates “brightest beacon at the frontiers of discovery”

The National Synchrotron Light Source II (NSLS-II) at Brookhaven Laboratory was dedicated February 6. NSLS-II, which produces extremely bright beams of X-ray, ultraviolet and infrared light, will examine a wide range of materials, including superconductors and catalysts, geological samples, and biological proteins, to accelerate advances in energy, environmental science and...

First prototypes of high-voltage feedthrough

With the delivery of two feedthrough samples for the 6 pin 30 KV rating, identified as a type D variant, Ceramtec North America Corporation (US) has begun to solve one of the big challenges at ITER.

What’s new for LHC Run II

Since shutting down in early 2013, the LHC and its detectors have undergone a multitude of upgrades and repairs. When the particle accelerator restarts, it will collide protons at an unprecedented energy: 13 trillion electron volts. The upgraded capabilities of the ATLAS, CMS, ALICE and LHCb detectors—plus the LHC’s extra...

Potential of molybdenum disulfide for extreme-temperature electronics

Many industries are calling for electronics that can operate reliably in a harsh environment, including extreme temperatures above 200°C. A team of researchers from the University of California, Riverside and Rensselaer Polytechnic Institute discovered that molybdenum disulfide, a semiconductor material, may be a promising candidate to make thin-film transistors for...

ADVERTISEMENT

Helium II

Helium II (He II) refers to the second liquid phase of the most abundant helium isotope (4He). Helium II is also referred to as superfluid helium. Helium II occurs once the temperature of the liquid helium drops below 2.17K. The phase transition between the first liquid phase of Helium (referred...

Primary Standards

Elie K. Track Hypres, Inc. elie@hypres.com http://www.hypres.com/ Primary standards involve the exact definition and realization of units of measurement for various quantities, time, length, mass, voltage, resistance, current, etc. International agreements based on the latest scientific knowledge define those units, and their realizations vary depending on the unit itself. For...

Shrink Fitting

Robin A. Rhodes Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Shrink fitting, (or “compression fitting” as it is sometimes called), is a method used to insert a pin or bushing into a housing or other assembly requiring an extremely tight tolerance fit. It can be used as an alternative to...

Telecommunications

From the Winter 2004 issue of Cold Facts magazine The recent M-Calc IV — 4th Industry Assessment workshop discussing military and commercial applications for low-cost cryocoolers, held in November in San Diego, highlighted progress being made in cryogenics as applied in telecommunications. The reliability and long lifetime of projects now...

Wind Tunnels

Dr. Robert Kilgore The development of the cryogenic wind tunnel is one of many significant breakthroughs in both cryogenics and wind-tunnel technology made during the past millennium. Interest in the development of high-speed commercial and military aircraft resulted in a review of problems of flow simulation in transonic wind tunnels...

An Issue of Pressure and Flow Rate in a Supply Tank

Please help solve this problem: A supply tank requires a vaporizer to generate sufficient pressure to pump stored fluid up into a vehicle or tank. The available head is limited as the tank level falls and it is important to minimize the system pressure drop to maintain the desired flow...

Using MLI on VJ Line Joints or Cryo Storage Tanks

When installing Multi Layer Insulation (MLI) blankets on VJ line joints or cryo storage tanks should they be wrapped and tied down tight or loose? These are usually pre-cut to size. Also should they have an access hole at the point of where the molecular sieve is installed to help...