High-temperature superconductivity starts with nanoscale electronic oases
High-temperature superconductivity doesn't happen all it once. It starts in isolated nanoscale patches that gradually expand until they take over.
ADVERTISEMENT
Leading physicist becomes executive director of NINT
An expert in nano-electronics will lead Canada’s National Institute for Nanotechnology (NINT) into its second decade. The NINT governing council has named Dr. Marie D’Iorio as its new Executive Director.
NIST physicists benchmark quantum simulator with hundreds of qubits
Physicists at the National Institute of Standards and Technology (NIST) have built a quantum simulator that can engineer interactions among hundreds of quantum bits (qubits)—10 times more than previous devices.
CMS discovers new particle
The Compact Muon Solenoid (CMS) experiment at CERN has submitted a paper for publication describing the first observation of a new particle, an excited beauty baryon called the ?b*0 (?b is pronounced "Csai - bee").
Test facility at KEK becomes an accelerator
On April 13 at KEK’s superconducting radio frequency test facility (STF), researchers successfully transported beam to the beam dump. The dump, located in the last part of the accelerator, is designed to absorb the energy of particles within accelerated beam. Now STF is no longer a test facility: it is...
New Light Source construction more than 70 percent complete
Construction of the $912-million National Synchrotron Light Source II (NSLS-II) at the U.S. Department of Energy’s Brookhaven National Laboratory is more than 70 percent complete – on schedule and on budget.
ADVERTISEMENT
Refrigerators and Liquefiers
Two of the most common terms used in cryogenics are “refrigerator” and “liquefier.” These terms describe similar and, as will be seen, in some cases identical components. A refrigerator provides cooling (that is, absorbs heat) at cryogenic temperatures. Refrigerators typically put a working fluid (such as helium) through one of...
Air Separation
Air separation is one of the largest, as well as earliest, industrial applications of cryogenics. In this process, cryogenic temperatures are used to separate air into its constituent gases: nitrogen (78.08%), oxygen (20.95%), argon (0.93%) and carbon dioxide (0.3%). Trace gases such as krypton, neon, xenon and helium total far...
Coefficient of Performance and Figure of Merit
The coefficient of performance (COP) is used to describe the effectiveness of refrigerators, including those operating at cryogenic temperatures. The COP is defined as the amount of heat removed at the cryogenic operating temperature of the refrigerator divided by the amount of work that must be applied to remove the...
Air Separation and Liquefaction
by Nils Tellier, PE, President, EPSIM Corporation (CSA CSM) nils@epsim.us All illustrations courtesy EPSIM Corporation Background History of Air Separation and Liquefaction This section builds on a rich history of methods to develop deep refrigeration and cryogenic liquefaction during the 19th Century. You are encouraged to read Cryo Central’s History...
Bose-Einstein Condensate
A Bose-Einstein condensate, first proposed in 1925 by Albert Einstein based on work done by Satyendra Nath Bose (the same Bose from whom the term boson is derived), is a super-cold state of matter in which almost all of the individual atoms have “condensed” down to the lowest possible quantum...
Cold Technology for Pest Control
While it does not reach temperatures cold enough to be called cryogenic, carbon dioxide snow is at the heart of a new way of dealing with unwanted pests. It utilizes a quick freezing process that takes advantage of the properties of carbon dioxide snow and has a number of benefits...
Cryogenic Finishing
The following 3 articles discuss the uses and procedures of various type of cryogenic finishing. 1) By Robin A. Rhodes, Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Cryogenic Deflashing is employed to remove undesired residual mold flash that remains on molded parts after they are removed or ejected from the...
Cryogenic processing for medical equipment, mining industry
Greetings from Australia. I am looking for a company that I might contact that has any experience or has done any research into cryogenic processing for medical equipment, in particular, joint prosthesis.
Cryogenic sealant for LNG fueled buses?
Where can I find a cryogenic sealant for my LNG fueled buses?
Material/gel/epoxy to transfer cold temperature of a cryo-box to a test article
I’m on the hunt for a material/gel/epoxy that will transfer the cold temperature of a cryo-box to a test article. The cryo-box is curved and the test article is at the same curvature. I’m looking for something to put between them to make the surface of the test article as...
Manufacture of brazed aluminum heat exchangers: need consultant
I’m seeking a consultant with experience in the manufacture of brazed aluminum heat exchangers for cryogenic applications. Is there anyone you could recommend to me?