Bill Corbin, a current Board Member in the Board of Directors at Taylor-Wharton International, LLC (TWI), has been appointed Chairman and Interim Chief Executive Officer.
Linde LLC, Air Products and Chemicals, Inc. and Air Liquide Industrial have all been awarded contracts to supply liquid nitrogen and liquid oxygen to six NASA facilities.
The $159 million cancer treatment center planned at Northern Illinois University will almost certainly miss the March 2010 completion date, a date that was required by the state when the project was approved.
The Spring 2009 issue of Cold Facts featured interviews from leaders in the industrial gases industry. Here are the interviews in their entirety, including information about each company's background and additional comments provided during the interview.
Technex Limited, a manufacturer of cryogenic tank semi-trailers for transporting liquid gases and liquid natural gas (LNG), has successfully completed the delivery of a cryogenic tank semi-trailer to Iceblick, a manufacturer and supplier of rare and industrial gases.
A dewar is a type of cryostat named after Sir James Dewar, the researcher who first developed the concept of a vacuum insulated container with silvered walls to reflect thermal radiation. Dewar was the first to liquefy hydrogen, and he created the device to store his discovery. The thermos bottle...
Stirling and Gifford-McMahon (GM) cryocoolers are two of the most commonly used cryocoolers in cryogenics. Both devices have a significant industrial base and operate at a wide range of temperatures and capacities. The thermodynamic cycles for both of these cryocoolers are quite similar. The Stirling cycle consists of a compressor,...
A significant commercial application of cryogenics is the liquefaction, transport and storage of natural gas. Liquefied Natural Gas (LNG) is generally 95 percent methane with a few percent ethane and much lower concentrations of propane and butane. LNG liquefies at 111.6 K. Unlike many applications of cryogenics, the motivation for...
Elie K. Track Hypres, Inc. elie@hypres.comhttp://www.hypres.com/ Primary standards involve the exact definition and realization of units of measurement for various quantities, time, length, mass, voltage, resistance, current, etc. International agreements based on the latest scientific knowledge define those units, and their realizations vary depending on the unit itself. For...
Robin A. Rhodes Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Shrink fitting, (or “compression fitting” as it is sometimes called), is a method used to insert a pin or bushing into a housing or other assembly requiring an extremely tight tolerance fit. It can be used as an alternative to...
From the Winter 2004 issue of Cold Facts magazine The recent M-Calc IV — 4th Industry Assessment workshop discussing military and commercial applications for low-cost cryocoolers, held in November in San Diego, highlighted progress being made in cryogenics as applied in telecommunications. The reliability and long lifetime of projects now...
Dr. Robert Kilgore The development of the cryogenic wind tunnel is one of many significant breakthroughs in both cryogenics and wind-tunnel technology made during the past millennium. Interest in the development of high-speed commercial and military aircraft resulted in a review of problems of flow simulation in transonic wind tunnels...
I am remembering in the 1970’s when astronauts were walking on the moon and carried oxygen in 300 ss bottles inside LN2 tanks which were filled and pressurized.
I am an engineer looking to improve our solenoid valve sealing on cryogenic medias. I was wondering if you knew of materials other then PTFE or glass filled PTFE that could be used for sealing.