Cryogenic process to separate high purity CO from mixture
I am looking for a cryogenic process to separate high purity CO (Carbon Monoxide) from a mixture of CO, CO2 and H2, plus small amounts of CH4.
ADVERTISEMENT
Cryo tempering business advice
My friend has a racing engine company in NC. He suggested I start a cryo tempering business there because of all the race shops around that source it out. Can you tell me or put me in touch with someone who can tell me what “turn key” would be required...
Open cycle coolers with capacity of 1,500 Q @ 100K?
Does anyone know of any open cycle coolers with a capacity of 1,500 Q @ 100K in the country, preferably as an off-the-shelf product?
Move cryogenic units in northern California?
Can you recommend any northern California companies that have expertise in moving cryogenic units?
Standards for fabrication of vessels/tanks?
I’m a total novice in the design and manufacture of cryogenic equipment, but nonetheless I’m a pressure vessel Designer/Engineer. Could you possibly advise as to any relevant standards/documentation that may be available with regard to, in particular, the fabrication of vessels/tanks?
Manufacturers of pressure regulators—liquid argon
I am trying to locate companies that manufacture and sell pressure regulators rated for dispensing liquid argon for a welding application. Do you know of companies that I could contact with this request?
ADVERTISEMENT
Helium II
Helium II (He II) refers to the second liquid phase of the most abundant helium isotope (4He). Helium II is also referred to as superfluid helium. Helium II occurs once the temperature of the liquid helium drops below 2.17K. The phase transition between the first liquid phase of Helium (referred...
Air Separation and Liquefaction
by Nils Tellier, PE, President, EPSIM Corporation (CSA CSM) nils@epsim.us All illustrations courtesy EPSIM Corporation Background History of Air Separation and Liquefaction This section builds on a rich history of methods to develop deep refrigeration and cryogenic liquefaction during the 19th Century. You are encouraged to read Cryo Central’s History...
Bose-Einstein Condensate
A Bose-Einstein condensate, first proposed in 1925 by Albert Einstein based on work done by Satyendra Nath Bose (the same Bose from whom the term boson is derived), is a super-cold state of matter in which almost all of the individual atoms have “condensed” down to the lowest possible quantum...
Cold Technology for Pest Control
While it does not reach temperatures cold enough to be called cryogenic, carbon dioxide snow is at the heart of a new way of dealing with unwanted pests. It utilizes a quick freezing process that takes advantage of the properties of carbon dioxide snow and has a number of benefits...
Cryogenic Finishing
The following 3 articles discuss the uses and procedures of various type of cryogenic finishing. 1) By Robin A. Rhodes, Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Cryogenic Deflashing is employed to remove undesired residual mold flash that remains on molded parts after they are removed or ejected from the...
An Issue of Pressure and Flow Rate in a Supply Tank
Please help solve this problem: A supply tank requires a vaporizer to generate sufficient pressure to pump stored fluid up into a vehicle or tank. The available head is limited as the tank level falls and it is important to minimize the system pressure drop to maintain the desired flow...
Using MLI on VJ Line Joints or Cryo Storage Tanks
When installing Multi Layer Insulation (MLI) blankets on VJ line joints or cryo storage tanks should they be wrapped and tied down tight or loose? These are usually pre-cut to size. Also should they have an access hole at the point of where the molecular sieve is installed to help...
Separated layers of ice over a pipe
I want to know that why there are different layers of ice over a pipe carrying a cryogenic fluid, each layer separated with clear marks / lines? What do these layers signify?