ADVERTISEMENT

The Most Powerful MRI Scanner in the World Delivers Its First Images

In September, the 11.7 Tesla MRI of the Iseult project, the most powerful in the world for human imaging, has just unveiled its first images. They validate the entire process that has enabled, thanks to multiple technological breakthroughs, the transformation of an “outstanding” magnet, delivered in 2017 to the French...

Book Review: The Safe Use of Cryogenic Technologies by Robert Done

It is becoming common for large-scale scientific projects to include cryogenic systems provided by other countries. Examples of this include CERN, the European Spallation Source, ITER and the PIP II project at Fermilab (CSA CSM). While these contributions are quite valuable, one of the big challenges in such projects is...

Cool Fuel: Hydrogen, Lenses and Lasers, Oh My!

The bar for getting the suffix of PhD after your name is high – you have to fundamentally change the philosophy in a field. As a faculty member responsible for training some of these individuals, I’m sometimes faced with the conundrum that advancing the philosophy implies that I have to...

Groundbreaking Alternative to Invasive Breast Cancer Surgery Now Available in Monroe NJ

Patients in Central New Jersey with early-stage breast cancer can now access a highly effective treatment that does not require traditional invasive surgery. Performed at Princeton Radiology's Minimally Invasive Care Center in Monroe Township by interventional radiologist Kenneth R. Tomkovich, MD, the procedure, called cryoablation, uses a small needle and...

ADVERTISEMENT

Helium II

Helium II (He II) refers to the second liquid phase of the most abundant helium isotope (4He). Helium II is also referred to as superfluid helium. Helium II occurs once the temperature of the liquid helium drops below 2.17K. The phase transition between the first liquid phase of Helium (referred...

Primary Standards

Elie K. Track Hypres, Inc. elie@hypres.com http://www.hypres.com/ Primary standards involve the exact definition and realization of units of measurement for various quantities, time, length, mass, voltage, resistance, current, etc. International agreements based on the latest scientific knowledge define those units, and their realizations vary depending on the unit itself. For...

Shrink Fitting

Robin A. Rhodes Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Shrink fitting, (or “compression fitting” as it is sometimes called), is a method used to insert a pin or bushing into a housing or other assembly requiring an extremely tight tolerance fit. It can be used as an alternative to...

Telecommunications

From the Winter 2004 issue of Cold Facts magazine The recent M-Calc IV — 4th Industry Assessment workshop discussing military and commercial applications for low-cost cryocoolers, held in November in San Diego, highlighted progress being made in cryogenics as applied in telecommunications. The reliability and long lifetime of projects now...

Wind Tunnels

Dr. Robert Kilgore The development of the cryogenic wind tunnel is one of many significant breakthroughs in both cryogenics and wind-tunnel technology made during the past millennium. Interest in the development of high-speed commercial and military aircraft resulted in a review of problems of flow simulation in transonic wind tunnels...

An Issue of Pressure and Flow Rate in a Supply Tank

Please help solve this problem: A supply tank requires a vaporizer to generate sufficient pressure to pump stored fluid up into a vehicle or tank. The available head is limited as the tank level falls and it is important to minimize the system pressure drop to maintain the desired flow...

Using MLI on VJ Line Joints or Cryo Storage Tanks

When installing Multi Layer Insulation (MLI) blankets on VJ line joints or cryo storage tanks should they be wrapped and tied down tight or loose? These are usually pre-cut to size. Also should they have an access hole at the point of where the molecular sieve is installed to help...