Cold Facts Digital – The go-to place for Cryogenics and Superconductivity

NASA tests game-changing composite cryogenic fuel tank

NASA recently completed a major space technology development milestone by successfully testing a large, pressurized cryogenic propellant tank made of composite materials. The composite tank will enable the next generation of rockets and spacecraft needed for space exploration.

Take two for cryomodule 2

With the repair and reinstallation of the cryomodule known as CM2, researchers at Fermilab are back on the road toward achieving the International Linear Collider’s R&D goal (named task force “S1”): operating a cryomodule at ILC gradient specifications.

Superconductor created from non-metallic solvent

A study led by Washington State University researchers has turned a fairly common nonmetallic solvent into a superconductor capable of transmitting electrical current with none of the resistance seen in conventional conductors.

International Linear Collider design is ‘good to go’

On June 12, scientists on three continents celebrated the completion of the design for the International Linear Collider (ILC), a next-generation particle collider.

$16.6B NASA budget clears House panel

A House panel approved appropriations legislation July 10 that would give NASA $16.6 billion for 2014, cutting agency spending back to levels not seen since 2007.

ISRO begins tests on indigenous cryogenic engine

The Indian Space Research Organisation (ISRO) has begun testing an indigenously developed cryogenic engine, mounted on the Geosynchronous Satellite Launch Vehicle (GSLV) — MK II.

Latest in Defining Cryogenics

Cold Compressors

A common way to provide cooling below the normal boiling point of helium (4.2K) is to reduce the pressure above the bath of liquid helium, thus also reducing the bath’s equilibrium saturation temperature. For example, to produce a 1.8K bath of liquid helium, the saturation pressure has to be reduced...

Kapitza Conductance

Kapitza conductance refers to the heat transfer between a solid surface and a fluid that covers that surface. Fundamentally, it describes the inherent difficulty in transferring energy from a solid to the fluid covering the solid surface. This phenomenon was first observed by P. L. Kapitza in 1941 while studying...

Thermosyphons

A thermosyphon (or thermosiphon) is a device that transfers heat via natural convection in a fluid. The natural convection is driven by gravity with the colder, denser fluid flowing downhill and the warmer, less dense fluid flowing back up. Thus, thermosyphons connect an object to be cooled with a reservoir...

Latest in Cryo Central

Cryogenic Electronics

Randall Kirschman, consulting physicist, Mountain View, California ExtElect@gmail.com Cryogenic electronics—the operation of electronic devices, circuits, and systems at cryogenic temperatures—has been a valuable technology for decades. Cryogenic electronics (also referred to as low-temperature electronics, or cold electronics) can be based on semiconductive devices, on superconductive devices, or on a combination...

Particle Physics: High Energy Physics

Cryogenics and High-Energy Physics 1. From symmetry magazine: http://www.symmetrymagazine.org/cms/?pid=1000627: Cryogenics is the study of how materials behave at temperatures near absolute zero. In high-energy particle accelerators, such frigid temperatures reduce the electrical resistance of wires in superconducting magnets, increasing the magnet strength and allowing faster particle acceleration. The same holds...

HTS Degaussing Systems

From the Spring 2009 issue of Cold Facts (Volume 25, Number 2): Thanks to a joint project by the US Navy and a number of industry partners, high temperature superconducting (HTS) technology is now at the heart of an advanced degaussing system aboard the USS Higgins at the naval station...

Magnetic Resonance Imaging

From http://www.superconductors.org: An area where superconductors can perform a life-saving function is in the field of biomagnetism. Doctors need a non-invasive means of determining what’s going on inside the human body. By impinging a strong superconductor-derived magnetic field into the body, hydrogen atoms that exist in the body’s water and...

Latest in Ask the Experts

An Issue of Pressure and Flow Rate in a Supply Tank

Please help solve this problem: A supply tank requires a vaporizer to generate sufficient pressure to pump stored fluid up into a vehicle or tank. The available head is limited as the tank level falls and it is important to minimize the system pressure drop to maintain the desired flow...

Using MLI on VJ Line Joints or Cryo Storage Tanks

When installing Multi Layer Insulation (MLI) blankets on VJ line joints or cryo storage tanks should they be wrapped and tied down tight or loose? These are usually pre-cut to size. Also should they have an access hole at the point of where the molecular sieve is installed to help...

Separated layers of ice over a pipe

I want to know that why there are different layers of ice over a pipe carrying a cryogenic fluid, each layer separated with clear marks / lines? What do these layers signify?

Using nitrogen as a cryogen

Is it possible to achieve -200˚C using nitrogen as a cryogen?

CATEGORIES