Cold Facts Digital – The go-to place for Cryogenics and Superconductivity

Cryogenics at the European Spallation Source

The European Spallation Source (ESS) is an intergovernmental project building a multidisciplinary research laboratory based upon the world’s most powerful neutron source. The facility will be built in Lund, Sweden. The ESS will use a linear accelerator (linac), which will deliver protons with 5 MW of power to the target...

Cryogenics Conference Moves to Dresden

Held in Dresden, Germany, for the first time, September 11-14, the international Cryogenics conference attracted 150 participants from 23 nations with 54 lectures and 28 posters presented. The exhibition comprised 18 companies. Students from the European Course of Cryogenics, sponsored by TU Dresden, which was held in the city at...

UH wind turbine superconductivity research project wins additional funding

A University of Houston engineering researcher and his team have received additional funding from the US Department of Energy (DOE) for a wind energy project that involves using superconducting wire to generate and transport electricity.

Fermilab scientists selected as APS fellows

Five Fermilab scientists have been named fellows of the American Physical Society, a distinction awarded each year to no more than one-half of 1 percent of current APS members by their peers.

Nexans and AMSC introduce fault current limiter for North American utilities

AMSC, a global solutions provider serving wind and grid leaders, and Nexans, an expert in the cable industry (both CSA Corporate Sustaining Members), recently introduced to the North American market a medium voltage superconductor fault current limiter (SFCL) solution that is designed to meet many of the challenges caused by...

“Crowning” the ITER cryostat from below solves columnar design problem

Columns are as old as civilization: for thousands of years, they have provided architects and engineers with a simple and sturdy solution to support heavy loads while leaving room to move around on the ground below. This traditional and reliable solution was to be implemented in ITER.

Latest in Defining Cryogenics

Transfer Lines

Transfer lines may in some real sense be thought of as the cryogenic fluid analogy of current leads. While current leads carry electrical power to where it’s required in a cryogenic system, transfer lines do the same with cryogenic fluids. Transfer lines range in complexity from very simple U-tubes containing...

Zero Boiloff

Zero Boil Off cryostats are those that contain liquid cryogens but are designed to eliminate or vastly reduce the boil off of the liquid. These cryostats combine some of the advantages of Cryogen-Free systems (e.g. ease of use and long operational lifetime) with the advantages associated with a reservoir of liquid...

Cryomodule

Cryomodule is a term that is most commonly used to refer to cryostats that contain superconducting radio frequency (SRF) cavities. Such cavities are used to accelerate charged particle beams and are a major component of modern particle accelerators. Using the term cryomodule to refer to cryostats containing SRF cavities appears...

Latest in Cryo Central

Primary Standards

Elie K. Track Hypres, Inc. elie@hypres.com http://www.hypres.com/ Primary standards involve the exact definition and realization of units of measurement for various quantities, time, length, mass, voltage, resistance, current, etc. International agreements based on the latest scientific knowledge define those units, and their realizations vary depending on the unit itself. For...

Shrink Fitting

Robin A. Rhodes Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Shrink fitting, (or “compression fitting” as it is sometimes called), is a method used to insert a pin or bushing into a housing or other assembly requiring an extremely tight tolerance fit. It can be used as an alternative to...

Telecommunications

From the Winter 2004 issue of Cold Facts magazine The recent M-Calc IV — 4th Industry Assessment workshop discussing military and commercial applications for low-cost cryocoolers, held in November in San Diego, highlighted progress being made in cryogenics as applied in telecommunications. The reliability and long lifetime of projects now...

Wind Tunnels

Dr. Robert Kilgore The development of the cryogenic wind tunnel is one of many significant breakthroughs in both cryogenics and wind-tunnel technology made during the past millennium. Interest in the development of high-speed commercial and military aircraft resulted in a review of problems of flow simulation in transonic wind tunnels...

Latest in Ask the Experts

An Issue of Pressure and Flow Rate in a Supply Tank

Please help solve this problem: A supply tank requires a vaporizer to generate sufficient pressure to pump stored fluid up into a vehicle or tank. The available head is limited as the tank level falls and it is important to minimize the system pressure drop to maintain the desired flow...

Using MLI on VJ Line Joints or Cryo Storage Tanks

When installing Multi Layer Insulation (MLI) blankets on VJ line joints or cryo storage tanks should they be wrapped and tied down tight or loose? These are usually pre-cut to size. Also should they have an access hole at the point of where the molecular sieve is installed to help...

Separated layers of ice over a pipe

I want to know that why there are different layers of ice over a pipe carrying a cryogenic fluid, each layer separated with clear marks / lines? What do these layers signify?

Using nitrogen as a cryogen

Is it possible to achieve -200˚C using nitrogen as a cryogen?

CATEGORIES