Cold Facts Digital – The go-to place for Cryogenics and Superconductivity

Alert! All Cryogenics Colleagues: Check out CSA on web radio!

The show, entitled "EZ Help You & More" aired on Sunday, September 14, at 11 a.m. EST at the following web address: http://ezhelp.org/listen.shtml. At around 11:30 a.m. EST, CSA Executive Director Laurie Huget “appeared” as a guest on this online radio show that seeks to clear up confusions in the...

NASA observatory gets new name

NASA has announced that its newest observatory, the Gamma-Ray Large Area Space Telescope, or GLAST, has been renamed the Fermi Gamma-Ray Space Telescope, in honor of Professor Enrico Fermi (1901-1954).

CSA Announces Election Results

Elections for CSA President Elect and Directors as well as a vote on acceptance of the proposed amended CSA Constitution and Bylaws closed on August 8, 2008 at 12:00 pm.

Hypres delivers Digital-RF (TM) receiver systems to ONR

Hypres Inc. has delivered two Digital-RF (TM) receiver systems to the U.S. Department of Defense's Office of Naval Research. The systems will serve as test beds to evaluate Digital-RF technology for wireless communications applications.

Zenergy announces extension of Rheinbach, Germany facility

Zenergy Power plc announced that it will expand its manufacturing facility based in Rheinbach, Germany, allowing the company to accommodate the expected increase in production of its ground-breaking HTS induction heater.

Synchronization of LHC beam transfer system a success

According to R&D Magazine, synchronization of the Large Hadron Collider's beam transfer system was shown to be successful through tests that began on August 8th. These preliminary tests are in preparation for the LHC's official first run on September 10, 2008, which will be webcast at webcast.cern.ch.

Latest in Defining Cryogenics

Regenerators

Regenerators or regenerative heat exchangers are a key component of cryocoolers such as pulse tube cryocoolers (Cold Facts, August 2014). Regenerator performance greatly affects the coefficient of performance of cryocoolers. Improvements in regenerator design and, in particular, regenerator materials have been an important factor in the improvement of the performance...

Pulse Tube Cryocoolers

The development of pulse tube cryocoolers has been a significant topic of research and development over the past 20 or so years. Pulse tube cryocoolers have a number of advantages over other types of cryocoolers and are now available commercially. In order to understand pulse tube cryocoolers, it’s best to...

Thermal Expansion

Thermal expansion refers to the change in size (length or volume) that a material undergoes as its temperature changes. In cryogenic systems this effect can be quite large and must be allowed for in the design. In isotropic materials, which include most engineering materials, the thermal expansion is the same...

Latest in Cryo Central

Air Separation and Liquefaction

by Nils Tellier, PE, President, EPSIM Corporation (CSA CSM) nils@epsim.us All illustrations courtesy EPSIM Corporation Background History of Air Separation and Liquefaction This section builds on a rich history of methods to develop deep refrigeration and cryogenic liquefaction during the 19th Century. You are encouraged to read Cryo Central’s History...

Bose-Einstein Condensate

A Bose-Einstein condensate, first proposed in 1925 by Albert Einstein based on work done by Satyendra Nath Bose (the same Bose from whom the term boson is derived), is a super-cold state of matter in which almost all of the individual atoms have “condensed” down to the lowest possible quantum...

Cold Technology for Pest Control

While it does not reach temperatures cold enough to be called cryogenic, carbon dioxide snow is at the heart of a new way of dealing with unwanted pests. It utilizes a quick freezing process that takes advantage of the properties of carbon dioxide snow and has a number of benefits...

Cryogenic Finishing

The following 3 articles discuss the uses and procedures of various type of cryogenic finishing. 1) By Robin A. Rhodes, Cryogenic Institute of New England, Inc. rrhodes@nitrofreeze.com Cryogenic Deflashing is employed to remove undesired residual mold flash that remains on molded parts after they are removed or ejected from the...

Latest in Ask the Experts

Any experience with Tungsten or Tantalum metal springs in a low temp environment?

I would like to use metal springs made of Tungsten or Tantalum in low temperature environment. Does anybody have any experience with such springs? More precisely, I would like to make compression springs by rolling tungsten or tantalum wire on a rod. I expect that, typically, the spring constant will...

Standards & specifications for pipe & tube couplings

I am interested in finding out more about cryogenic applications and what standards, specifications and test methods (ASTM, etc.) are required for qualification of pipe and tube couplings.

Looking for a test house to test the static coefficient of friction under cryogenic conditions

I am looking to find a test house that is capable of testing the static coefficient of friction under cryogenic conditions. We can be flexible on most of the test parameters, including the test coupon configuration, but we’re looking for a test house that can provide the following test environment:...

Approximating pressure changes over time in cryogenic cylinders

I am an Air Resources Engineer with the California Air Resources Board (CARB). My senior management has asked me to investigate approximating pressure changes over time in cryogenic cylinders that contain LNG. So far, I have taken a stab at the problem, seeking to take a back-of-the-envelope approach (as directed...

CATEGORIES